Originally Posted by Live

This video is not credible, because you use the lever to lift the reactor and constantly switching scale on/off. Why are you doing this???




This question has been asked before.

The only reason is because the scale has an automatic switch off system.

The reason the scale is switched on and off, is because otherwise the scale starts from zero when is released and one cannot see the real weight.

Now we have put everything back on the load-cell and computer scale.

Systems are hanging as digital scales are no good as the Magravs of the systems interferes with their electronics and the reading goes allover the place.

The black sack on the table is where we load our radiation detectors to monitor the environment immediately around the systems in given conditions to observe if there is any nuclear activities. These are the most advance systems used and has to be in the lab for the safety reasons.

With star formation one needs for the who platform to be hanging and not for it to be on the floor that the effects of small changes in the Magravs of one system can show how it effects the motion and the weight of the system.

1 bar means gas pressure at the point before entry into the measuring systems prior to loading.

We measure the Magravs of the day and then we set to achieve this for lift. 90%means; 90% of Magravs of that day in the lab and that day the measurement was around 900 and we achieved 835 at this point reduction in weight started that is why the video suddenly started as we did not expect such a change and so rapidly.

Speed is keept at 500 rpm at all times.

In today's test we have observed something more fundamental and opposite to the last test, as the Magravs of the systems are going backwards instead of increasing. The test is at the moment on going and if we see something interesting we will release the video of it.